Tuesday at TR

Tappet interlock diagram for ET ground frame
(photo courtesy of Ian Cowan)

Jim machining an axle box bearing for Horden
(photo courtesy of Dave Dixon)

Loading rail at Engine Curve
(photo courtesy of Nigel Wheeler)

Ian chopping logs at Engine Curve
(photo courtesy of Nigel Wheeler) 

 Colin & Steve levelling ballast in ET loop point
(photo courtesy of Dave Dixon)

Ian & Nigel topping up transmission fluid
(photo courtesy of Dave Dixon)

Ian offloading range for ET run round loop
(photo courtesy of Dave Dixon) 

Steve fitting a chair for a loop point closure rail
(photo courtesy of Dave Dixon)

Colin placing the remainder
(photo courtesy of Dave Dixon)

Nigel placing a rail
(photo courtesy of Dave Dixon)

I was at an HRA funding seminar at Crewe
- this is Andrew Scott on crowd funding