 |
| Peter cutting down a cotter pin for Horden |
 |
| Nigel fitting a plate under the blade ends of the new switch |
 |
| George & Steve trying to pull part of the switch into alignment ..... |
 |
| ...... before fastening down |
 |
| Bill trying to realign the switch |
 |
| George & Nigel drilling the blades ..... |
 |
| .....for Dave & Bill to fit anchors |
 |
| Nigel & George adding more fastenings, watched by Maggie |
 |
| Steve checking the blade opening for fitting a tie bar |
 |
| Dave adjusting a tie bar |
 |
| Steve, Geoff & Shaun start to fit the remaining screws |
 |
| Shaun is knocking in the ferrules while Geoff drills |
 |
| Steve using the impact wrench |
 |
| Fitting a tie bar |
No comments:
Post a Comment