 |
| Moving the replacement blade by hand |
 |
| Inserting the blade vertically into the chair jaws |
 |
| Cameron replacing a broken chair |
 |
| Dennis & Cameron fitting a 4 hole plate where there was previously a short plate |
 |
| George cleaning more fishplates to replace another 2 hole pair (seen to the right) |
 |
| Ian having problems with a blunt drill |
 |
| John diving into the electrical intake |
 |
| George & Bill fastening the blade end timber |
 |
| Fastening down one leg - Nigel lifting sleeper ends; Geoff fitting ferrules & screws |
 |
| Having checked the gauge, Dennis & Geoff are fitting ferrules & screws ..... |
 |
| ..... for Bill & George to fasten down |
 |
| Cameron fitting an anchor to the replacement blade |
 |
| Dennis, Steve & Geoff fitting the stretchers to the blade ends (photo courtesy of Bill Thain) |
 |
| Strapping a pivot carrier to adjacent timbers |
 |
| Ian casting an eye over alignment of pulleys & rods (photo courtesy of Bill Thain) |
 |
| Fitting a pivot & crank for point rodding |
 |
| Nigel & Ian starting to fit blade end detection |
No comments:
Post a Comment